ASDSO Dam Safety Toolbox

Common Questions about Siphons: Difference between revisions

From ASDSO Dam Safety Toolbox
Jump to: navigation, search
(Created page with "==Siphon as an Outlet Replacement== 4 Key Questions that must have a Yes answer: #Is the dam small enough and at a low enough elevation so that the use of a siphon is physically possible? #Will abandonment of the original outlet works not impact the reservoir's ability to pass the required inflow design storm (dictated by regulatory agencies)? #Is there an alternate means to passively control reservoir level to prevent overfilling? #Can the siphon reasonably be used for...")
 
No edit summary
Line 1: Line 1:
==Siphon as an Outlet Replacement==
==Can a Siphon Replace an Outlet at My Dam?==
4 Key Questions that must have a Yes answer:
The answer to the following 4 key questions must be YES:


#Is the dam small enough and at a low enough elevation so that the use of a siphon is physically possible?
#Is the dam small enough and at a low enough elevation so that the use of a siphon is physically possible?
Line 19: Line 19:
*[https://3.238.206.13/images/9/9c/Drawdown_System_Selection_Flow_Chart.pdf Drawdown System Selection Flow Chart]
*[https://3.238.206.13/images/9/9c/Drawdown_System_Selection_Flow_Chart.pdf Drawdown System Selection Flow Chart]


Note: The content on this page was originally created as part of DamOutletWorks.org (DOWL, 2018). It has subsequently been updated and reformatted as part of the Dam Safety Toolbox.
''Note: The content on this page was originally created as part of DamOutletWorks.org (DOWL, 2018). It has subsequently been updated and reformatted as part of the Dam Safety Toolbox.''

Revision as of 05:51, 16 September 2022

Can a Siphon Replace an Outlet at My Dam?

The answer to the following 4 key questions must be YES:

  1. Is the dam small enough and at a low enough elevation so that the use of a siphon is physically possible?
  2. Will abandonment of the original outlet works not impact the reservoir's ability to pass the required inflow design storm (dictated by regulatory agencies)?
  3. Is there an alternate means to passively control reservoir level to prevent overfilling?
  4. Can the siphon reasonably be used for emergency drawdown if needed (in combination with pumps in some cases)?


Other Questions to Consider

References

Note: The content on this page was originally created as part of DamOutletWorks.org (DOWL, 2018). It has subsequently been updated and reformatted as part of the Dam Safety Toolbox.